Acoustic underlayment HardFloor for Wood Flooring

HardFloorAcoustic HardFloor underlayment for wood flooring t is a lightweight underlayment system that has been specially designed for floated or glue down wood flooring. Acoustic cerazorb-picUnderlayment  offers high energy impact with low weight and will remain unchanged after repeated impact loads. Acoustic Underlayment for wood floors is a expanded polypropylene underlayment that will not rot, swell, absorb water and is anti microbial. Acoustic Underlayment has been tested and has the performance equal to 1/2″ recycled rubber. Acoustic Underlayment can be bonded to approved sub floors using ANC-T-950 bond coat adhesive.

 * Up to 25 times lighter than 1/4″ backer board ”
* Synthetic cork product” will not rot, support mold & mildew or absorb moisture
* Thin profile 3/16″ thick, 4′ x 4′ sheets Lightweight only 28 lbs per box,
* 25 sheets per box, 400 sf,
* Credible acoustical and crack suppression
* Optional Peel & Stick available Passes Robinson test to light commercial rating

Acoustic HardFloor Underlayment for Wood Flooring Specs

Acoustic Underlayment for Wood Flooring Specs

SOUND CONTROL UNDERLAYMENT

GENERAL SECTION INCLUDES

Sound-reducing underlayment for ceramic tile and stone flooring.

RELATED SECTIONS.

09 30 13 – Ceramic Tiling & 09 30 16 – Quarry Tiling

REFERENCES

S. Department of Housing and Urban Development (HUD): Guide to Airborne, Impact, and Structure Borne Noise Control in Multifamily Dwellings.

SUBMITTALS

  1. Submit under provisions of Section 01300.

Product Data: Manufacturer’s data sheets on each product to be used, including:

  • Preparation instructions and recommendations.
  • Storage and handling requirements and recommendations.
  • Installation methods.

Selection Samples: For each finish product specified, two complete sets of color chips representing manufacturer’s full range of available colors and patterns.

QUALITY ASSURANCE

Manufacturer Qualifications: The manufacturer shall be a firm with a minimum of two years of successful experience in manufacture of products with similar requirements.

Installer Qualifications: The installer shall be a firm with a minimum of five years of successful experience in installation of products with similar requirements.

DELIVERY, STORAGE, AND HANDLING

Store products in manufacturer’s unopened packaging until ready for installation.

Store and dispose of solvent-based materials, and materials used with solvent-based materials, in accordance with requirements of local authorities having jurisdiction.

PROJECT CONDITIONS

Maintain environmental conditions (temperature, humidity, and ventilation) within limits recommended by manufacturer for optimum results. Do not install products under environmental conditions outside manufacturer’s absolute limits.

EXAMINATION

Do not begin installation until substrates have been properly prepared.

If substrate preparation is the responsibility of another installer, notify Architect of unsatisfactory preparation before proceeding.

PREPARATION

Clean surfaces thoroughly prior to installation.

Prepare surfaces using the methods recommended by the manufacturer for achieving the best result for the substrate under the project conditions.

INSTALLATION

Install in accordance with manufacturer’s instructions.

PROTECTION

Protect installed products until completion of project.

Touch-up, repair or replace damaged products before Substantial Completion.